Futon. Saturday , April 14th , 2018 - 23:55:21 PM
When the futon industry was born back in the 1980's, the frames were well thought out and well constructed. Whether it was softwoods or hardwoods, the frames featured good fundamental designs made from solid wood. These futon frames would incorporate new working mechanisms and ideas in operation that made futons appealing not only in their design but in the quality of materials and construction that went into them. The futon industry was doing well and growing with these frames heading into the 1990's but then the black metal futon frame came onto the scene.
Another issue the black metal frames suffered from were bending stretcher bars or rails. Again the hollow nature of these strecther rails presented issues with breakage and bending. Early designs involved a steel tooth design that would fit into pocket welds on the arms. These would snap off over use. The alternative design was to run a bolt through the arms and into the rails. While better it still did not address the issue of bending stretcher rails.
Most specialty futon retailers pay little to no attention to black metal futon frames. Retailers I've spoken to have said that the black metal futon frame is the number one service headache when it came to futons with over 95% of service issues being the failure of a black metal frame component. Replacing these parts were made more difficult by the fact the manufacturers were located overseas and obtaining the parts past the 90 day warranty period often involved the retailer having to purchase the replacement parts and charging the customer.
Any content, trademark’s, or other material that might be found on the Streatchforming website that is not Streatchforming’s property remains the copyright of its respective owner/s. In no way does Streatchforming claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.